I was bummed that the brush roller didn't work. I got it on our shark vacuum but it's too tight for it to spin/roll so we had to order straight from Shark which is more expensive. Everything else in this pack fit perfectly though. Will definitely buy again when we start getting low on supplies.

Tug lightly on the end on the side where the flat orange piece is. 1. A slight gap should open up if there's any remove debris inside the inner orange bearing, the gab is tiny so tweezers work. 2. I sprayed just a drop or two of dry-lube inside and had zero issues after installing. If you don't have a can of dry-lube around then silicone spray lube will work also. DON'T use a lot, just drop or two or quick shot with the can.

Everything fits perfectly and now my old boy is back to new. The brush does seem to get stuck like others have said. I took it apart and couldn't figure out why so I just sprayed it with some WD-40 and it has not happened since.

Purchase this for our Shark vacuum. Everything fit perfect.

This was generally a good deal except that the most important item to me was the brush roller and it doesn't fit my Shark model RV2610WA. Also the side brushes are too long but at least they can be trimmed otherwise they get caught in the main wheel. I ordered another kit because I thought the brush roller not fitting was a fluke. Both times I received ones that have an orange cap instead of a gray one and the roller itself is a different color blue. Apparently the brush in the kit is slightly thicker than the original so it doesn't drop right into place like it should.

Would have been a good set at a good price, everything looked sturdy and correctly made. Brushroll and the compartment cover seemed even better than original except the roller is a tiniest bit too long and thus to tight and unable to spin so creates an error message that the brushroll is stuck/jammed.

Parts fit perfectly, they were clean and nothing was broken or compressed even though the package was just an envelope. I guess they figured out how to pack it without requiring a box.

Overall you get quite a lot for the price. The filters and the sweep brushes all seemed very comparable to the factory items. The roller brush however gave me some problems. I noticed when installing it that the gap between the roller body and the head was very tight and sure enough shortly after starting the vacuum It gave an error that there was an obstruction. I turned it over and found that the roller had locked up and I was unable to turn it. I removed it, turned the head and it freed up. I reinstalled it but had the same results. I was able to remedy the issue by removing the head and sanding it down with some 80 grit sandpaper on a flat surface. This increased the gap between the head and the roller and has kept it from locking up. I'd say this is still not a terrible value but I will be trying another manufacturer the next time I order replacement parts.