product image
product image preview
product image preview
product image preview

Desunia Medium Duty Nylon Table & Furniture Levelers - 1/4" Threaded Shank w/T-Nuts - 400 Lb. Capacity - Adjusts from 0" to 9/16" - Brown - 4 Pack

6.99

Desunia Medium Duty Nylon Table & Furniture Levelers - 1/4" Threaded Shank w/T-Nuts - 400 Lb. Capacity - Adjusts from 0" to 9/16" - Brown - 4 Pack

4.4

Highest ranking 101

10 comments

$6.99

· PLENTY STRONG - Each leg can support 100 lbs. so a set of 4 can handle furniture pieces as heavy as 400 lbs.! · FLOOR FRIENDLY - The nylon foot is an inconspicuous 1" in diameter and is kind to hardwood floors! · LOTS OF ADJUSTMENT - Each leg can be adjusted from 0" to 9/16". Plenty for even the most out-of-whack floors! · EASY PEEZY INSTALLATION - Drill a 5/16" hole in each corner, tap in T-nuts, screw in leveler. DONE! · YOU GET - 4 brown levelers & 4 T-Nuts

Related products

Reviews From
avatar

dan brademeyerReviewed in the United States on January 18, 2017

These were awesome for my DIY table I built. They are very easy to install into the furniture, I believe its just a 5/16" drill bit (the furniture levels arrived with installation instructions) and then you just hammer them into your drilled holes and the claws grab the wood and lock them in place! They made leveling my kitchen table a breeze and were so easy to install. The only thing is that the white nylon plastic feet are only about 3/4" in diameter, so it was a little smaller than expected, but it turns out the small size actually works great because they aren't visible to anyone and the table doesn't slip or slide around on my laminate flooring.

avatar

SEPReviewed in the United States on August 26, 2016

These little levelers work very well for my application. I'm an artist who needs to work on a surface that is precisely level at some times, but adjusted to tilt slightly in different directions at different times. The DHS medium duty Nylon Furniture Levelers do the trick very nicely and precisely. The white nylon feet even have fine texture of little spikes around the edges to make the leveling adjustments easier and more accurate. I couldn't be happier, so I'm buying a second pair to make a second leveling stand!

avatar

PervySageChuckReviewed in the United States on July 5, 2016

These were ALMOST perfect for my needs. I say ALMOST perfect because I wish that these came in different bolt lengths. I would have preferred it if the bolt length was available in a 1/2" or a 5/8" length instead of just the 1" length as I did have to use my Dremel tool to trim the bolts a bit shorter as I needed to install them on a 3/4" thick baseboard as the bottom support for the central pillar on the chessboard table I am building. However, they were quite easy to trim and now serve me very well for this project.

avatar

Robert LyonsReviewed in the United States on February 21, 2017

I worked on fixing a table for a friend of mine. The one leg of a trestle table had broken. I glued it back into place but the table would not level out even after the repair. Also two of the orginal glides that had been on the table had fallen off. I purchased these to resolve all of these problems and they worked perfectly. I can now level the table and it glides over the hardwood floor without scratching the floor. These were exceptionally easy to install. I would not hesitate to buy these again.

avatar

RACRReviewed in the United States on October 9, 2016

My husband made a sofa table with legs of steel. To protect our floor and to eliminate the wobble we purchased this product. I was going to give it a three because they were too small for the project, but they did the job of stablizing the table anyways.

avatar

Stephen DeanReviewed in the United States on November 21, 2016

Great product. Install was a piece of cake. I was installing on a vintage piece, so I was afraid the teeth on the hardware would split my wood. Four little pilot holes addreessed that concern. My home is a 70s house, and our floors have more waves than a Sunday Rockies game. These feet helped get my danish wall unit level and plumb.

avatar

BoyntonOUReviewed in the United States on April 6, 2016

These are fantastic. Simple to install and sturdy. I used them to reinforce a wine bar's legs that is also holding up a 55-gallon aquarium. So strong and easy to extend, they lifted the bar up when I was tightening them. Highly recommended.

avatar

dion m.Reviewed in the United States on September 24, 2022

Not a bad product. Wish the teeth that go into the wood were thinner. Will split smaller legs.

avatar

M. WrobelReviewed in Canada on August 13, 2024

Easy to install and adjust, the flat nylon bottom allows even heavy furniture to be easily moved around as needed, and best of all, appears safe for hardwood floors (no scratches). Exactly what I was looking for. A good buy in my opinion, I'm happy.

avatar

NTGOGOReviewed in Canada on October 15, 2023

Too bad could not buy smaller quantity - But it worked perfectly