Make sure there is no air in the system before you power up! I ran this pressure washer for just over an hour right out of the box with no issues whatsoever. Ten minutes later I ran the machine for another hour and a half and I'm pleased to say, no issues. Pressure is so strong I have to pull the trigger and then power up using the switch. Fast cleaning, several tips that snap into place. I feel like this is a tool that makes my "must have list". A swivel on the pressure hose is needed to stop the typical wrestling match to make it straight or roll it up... GREAT TOOL @ economy pricing and a real work horse...!

I bought this brand because my Mom had one and hers had broken (she had it for awhile). Read the instructions and make sure you have air out before turning it on (there's youtube videos on this) but it works really well. It's not really designed for large spaces because it will take you awhile but we did a large carport area in sections over several days and it did the job. It has 3 spray nozzles but we only used one for this particular job. The nozzle for the soap would be good for washing your car because it's not as strong a stream. There is a nozzle that makes a more concentrated stream but we didn't have use for it this time that we used it. We ran it for several hours straight with no issues. Had plenty of electrical line and plenty of hose line for what we needed to do. Easy to move around as it has wheels but we did not try and pull it around like some of those that are lower to the ground. I didn't feel like we needed to move it all that much to cover the areas we were working on. The carport was heavily covered in algae so it did take smaller stronger sprays to get the algae off. In the one area not exposed to the sun, it went much faster to get the layers of dust off and some stains. We used a degreaser (not through the detergent bin) to get some of the more heavily stained areas clean. I haven't used any other brands but I can recommend this one as being sturdy and stores super nice with everything fitting in the device itself.

It works okay. It got enough power to wash the wheel rims (arguably the hardest thing to clean). The hose and the power cable are long enough so I can wash my car without moving it. One issue I have is the soap tank. Once you put the soap in there is only one way out and there's no way to shut it off.

I have only used it for one day but it ran for about 5 hours straight and had no issues. it was easy to assemble, has no leaks and 1700 PSI was plenty of power to wash my patio, deck, porch, and driveway. I like how the bucket holds the hose when not in use and has corner slots to hold the extensions and gun parts when broken down. while the gun is assembled I'm able to rest it on the area where you wrap the power cable while its not in use. everything about it was convenient and thoughtful. the only thing I would change is the built in nozzle holder. Instead of 2, id like to have 5 but for $5 I bought a holder that I zip tie to the arm and I'm good to go. Id recommend it to a friend or neighbor for the $100 price tag, its got the value.

I’ve only had the Kärcher K2300PS for two days, but I got to put it to work today thanks to one of the first nice spring days—and it didn’t disappoint. Used it to wash both of our cars, and the results were fantastic. The pressure was strong and consistent, and the different spray nozzles made it easy to switch between rinsing and blasting off the winter grime. The built-in detergent tank worked great too—made the job quicker and more efficient. Setup was straightforward, and I love the hose reel for keeping everything tidy. For a first-time use, I’m seriously impressed. If the performance holds up over time, this is going to be my go-to tool for cars, siding, the driveway—you name it. So far, so good. Spring is off to a clean start!

Karcher K1700 pressure washer: Assembly is very easy -- wheels and handle. If you just use the supplied hose then screw it on to the outlet and onto the spray nozzle. Screw the garden hose adapter on and screw a garden hose on. Plug it in and it should work, mine did. I bought a Karcher because a review by Pan the Organizer who said his Karcher K5 lasted 10 years and still works but it was time to get a new pressure washer. As I recall he thought Karcher had a superior pump. I watched a couple reviews of the K-1700 as well. So, as I had no idea and the K-1700 seemed what I was looking for, I bought it. I have light work -- a small cement patio, some siding and vehicles. Note that the high-pressure fittings are M22-14 not M22-15 as many electric pressure washers use so I ended up ordering another set. I knew the foam cannon used M22-14 when I bought it. I didn't see any reference to the fittings in the Karcher manual or brochure. I did see that some Karcher products fit the K2 or K5 but not the K-1700 but was left to assume why. I guess Karcher wants us to buy their brand. I added some quick disconnect fittings. I had a leak on the appliance end of the pressure hose. It seemed the o-ring on the hose is too large and was pushed down when I inserted/screwed the quick disconnect on. I took an o-ring off another fitting and the same thing happened. I then added a garden hose washer to the supplied pressure hose fitting after cutting it down so it fit and replaced the o-ring with a piece of Teflon packing "string" which fit into the o-ring groove perfectly. I used silicon grease to get it to stay put. No leaks. I was testing with a car wash foam cannon which worked very well and produced a persistent snow foam coating. The pressure hose went onto the pressure washer without any leaks. The garden hose adapter leaked some, but I didn't tighten with a wrench which I'll do next time. I ordered another quick connect set for the high pressure fitting on the K-1700 and a couple different sets of o-rings to have on-hand. The electric cord wraps nicely on the supplied handle arms. CONS: 1. Nozzle storage is limited to two regular nozzles and one hybrid rotating type nozzle (as supplied). So, I don't have a place to put other nozzles except in a bag in the storage box. 2. No built-in good way to keep the supplied pressure hose coiled neatly on the unit. The hose is a little stiff and making it fit in the storage box may not work well or conveniently and being slick plastic will likely push out. I added a piece of PVC pipe that went through the handle and that keeps the pressure hose coiled up around the handle and the storage bin. I'll fit it with some closed cell foam to keep it in place as I want to be able to remove it. My initial impression is that I think the supplied hose will work for me but time will tell if a longer, more flexible hose will be needed. The K1700 seems like a good unit overall particularly for the price. I cannot see paying lots for something I don't expect to use that often. Winter storage: per the manual, be sure to run it out of water. It seems that water runs out when I tilt it to the inlet fitting but the manual said to run it until just out of water. I think I can handle that.

I purchased this pressure washer to detail our vehicles (foam and rinse each vehicle’s paint, engine and undercarriage), power wash mats, etc. I am a weekend warrior … not a professional detailer. I only detail about 1-2 cars per week (on average) … so, I don’t need an expensive pressure washer. Given my needs, my research pointed me to this unit as my best value … being able to provide low enough water pressure to avoid damaging a vehicle’s paint while being both affordable and of reasonable build quality for weekend warriors use. In addition to good function and good value, I also wanted ease of access to (and storage of) the unit. So, I installed my unit on a wall shelf and added an MTM Hydro 50-foot hose reel below the wall shelf (see photo). Pros: The K1700 cube comes with fittings that are commonly used by higher quality pressure washers (M22 threads and 1/4” fittings). I bought and installed MTM Hydro 1/4" stainless steel quick connects to easily connect / disconnect the unit from my home’s water source, its hoses, etc. that were readily available and didn’t require special adaptor fittings to work on the K1700. This was important to me because I live in a climate with freezing temperatures in the winter, don’t have a heated garage and therefore store my setup in my basement for the winter. The K1700 cube is relatively light and compact … facilitating my shelf install. The K1700 cube has an easy to use and convenient foot pedal to turn the machine on and off. Because my setup is on a wall shelf, I simply press the pedal with my hand. The K1700 cube has a water intake on the left side and its water outlet on the front. These locations work very well for connecting hoses for the summer (and disconnecting the machine and the hoses for winter storage) … especially when you have a wall shelf installation. The K1700 cube’s water pressure and water output (that I have reduced by using a 40-degree 3.0 orifice MTM Hydro quick connect nozzle and an MJJC Foam Cannon with 1/4 Inch Quick Connector) is sufficient for my applications. This machine comes with a 25-foot power cord with built-in GFCI (ground-fault circuit interrupter) protection designed to shut off the machines electric power in the event of a ground-fault (such as contact with water.). This hose length should be more than adequate for most every installation. The K1700 cube has a built-in storage container. I use mine for storing extra nozzles (I bought a set of MTM Hydro 3.0 quick connect nozzles), etc. Finally, the K1700 cube comes with a 3-year warranty (the cube unit … I don’t believe the warranty covers all the accessories). This is a very good warranty for a more “budget” pressure washer. I should point out that more “budget” units like the K1700 (although well made) are not designed to last forever. So, for Karcher to warranty this unit suggests their confidence in the product. Certainly, based on my experience so far, the K1700 cube appears well-made and has not given me any problems. Cons: The K1700 is not designed for cleaning decks, driveways, etc. If you are seeking a pressure washer to perform these tasks easily, look for a higher PSI machine. This is not a problem for me. I use my K1700 cube strictly for car detailing. I have a much more powerful pressure washer for handling tasks that require higher PSI ratings. This machine comes with “budget” accessories … a 20 foot pressure washer hose, a pressure washer gun and wand and some nozzles. The problem is that all lower cost pressure washers come with what I would describe as “budget” accessories (hoses that are too short in length, inflexible and tangle and break easily, pressure washer guns and wands that are made out of lesser quality parts), etc. I left the attachments that came with my K1700 cube in the box and bought higher quality attachments … a hose 50 foot MTM Hydro Kobrajet hose, a Mosmatic NEO pressure washer gun with swivel (again that can be quickly and easily connected / disconnected using my quick connects) … am very happy that I did. It has greatly enhanced my pressure washing experience … eliminating fighting with lesser quality components as well as making my pressure washer very convenient to use and to put away / store after use. The K1700 cube comes with a build-in soap dispenser. For me, this is a con because I use a foam cannon (or other foamers and sprayers) to apply cleaning products (like car shampoo, wheel and tire cleaners, engine degreasers, etc.). I never use built-in “features” like soap dispensers … which I should point out only function as a sprayer (not a foamer). Recommendation: I highly recommend the Karcher K1700 Cube. In my humble opinion, I am of the view that this unit was by far the best value for money to meet my needs (for all the reasons that I set out above). Notwithstanding, I suggest that if you are considering buying this unit (or any other unit that includes accessories with the unit) for car detailing (or other applications), that you replace the accessories (pressure washer hose, spray gun and nozzles) that ship with the unit with higher quality accessories. You also may want to consider buying quick connectors to make attaching / detaching pressure washer guns, foam cannons, etc. faster and more convenient. I made these modifications right at setup. But, these upgrades can be done at any time. It has certainly improved my car detaining experience.

5 stars despite a minor but easily fixed problem. After 5 minutes use the cleaner was not as effective and the photos show why. A small piece of plastic “swarf” had blocked one of the white nozzles orifice. After removing the two retaining clips/nozzles/”O” rings I connected the surface cleaner to the pressure washer and pulled the gun trigger to flush any other bits of “swarf” out of the pipework. The piece of swarf* sticking out of the nozzle was cut off and the nozzle blown through with compressed air to eject the remaining swarf* out of the back of the nozzle (* the two black bits in front of the right hand “O” ring) If I had not had compressed air to use I would have tried to vacuum out the the nozzle rather than poking the swarf out with a pin and possibly damaging the nozzle. So, if you buy this surface cleaner, you may want to consider removing the two retaining clips/nozzles/”O” rings and flushing the pipe work before you first use the cleaner.

We used this for cleaning our stone patio and sidewalk. It made a good difference and gave the stones a fredh look. The best part is that it keeps the dirt down with no sand spraying all over the plave. What an improvement to the process. Highly recommended.

Faulty (damaged) product, returned for a full refund. Happy with the outcome.

Reputable brand at an affordable price