product image
product image preview
product image preview
product image preview
product image preview
product image preview
product image preview
product image preview

GOOACC GRC-18 100PCS 7mm 8mm 10mm Nylon Push Expansion Screws Replacement Kit,Bumper Fastener Rivet Clips GM 21030249 Ford N807389S

8.99

Other platform prices

GOOACC GRC-18 100PCS 7mm 8mm 10mm Nylon Push Expansion Screws Replacement Kit,Bumper Fastener Rivet Clips GM 21030249 Ford N807389S

4.5

Highest ranking 101

13 comments

$8.99

Other platform prices

· Great Material - These bumper clips are made of high-quality black nylon material, anti-wear and anti-corrosion, would not break or crack easily during use. · WIDELY APPLICATION - Theses push clips are widely used for trim panel clips, door trim clips, door panel clips, bumper clips, Fender clips, engine cover and splash shield retainers replacement. It always covers some applications include telecom equipment, motor vehicles, domestic appliances, furniture and electrical equipment. · 7mm hole great for GM: 1595864,1605396; Chrysler: 6030441; Ford: 388577S,W705589-S300 .Fits for Ford, GM, Chrysler, Theses push clips are widely used for trim panel clips, door trim clips, door panel clips, bumper clips, Fender clips, engine cover and splash shield retainers · 8mm hole widely used for door trim, radiator shield yoke, fender, bumper, side skirt, grille, engine cover and splash shield retainers · 10mm hole great for Acura: 91503-SZ3-003 Honda: 91503-SZ3-003,Fit for HONDA 1997-2011 Accord 1997-2010 Civic 1999-2010 CR-V 1984 1991 CRX 1993-1997 Del Sol 2003-2010 Element 2007-2010 Fit 2000-2006 Insight 1996-2010 Odyssey 2003-2010 Pilot 2007-2001 Prelude 2006-2010 Ridgeline 2000-2008 S2000 Acura 2001-2003 CL 1996-2001 Integra 2001-2010 MDX 2007-2010 RDX 1996-2010 RL 2002-2006 RSX 1997-2010 TL 2004-2010 TSX

Related products

Reviews From
avatar

Richard SReviewed in the United States on February 12, 2017

These replaced the broken clips on my front fenders of my Stock JK Jeep Rubicon after a little rock rubbing on a trail. Getting the old, broken clips out was a bit tricky and required I remove a few press in clips and 1 both from the inside of the fender, above the tire, so I could pull the fender out and slide my hand between the body and fender to insert the new clip in the notch of the fender. Make sure you fully seat the cip in the fender notch to ensure you have correct alignment with the hole in the body and ensure you have the fender sit flush to the body. I highly recommend getting the clip removal tool to make it easier to remove the broken clip that's left in the hole in the body.

avatar

ColoToddoReviewed in the United States on March 19, 2016

I purchased a package of 25 of these when I purchased a replacement set of fender flares for my Jeep Wrangler JKU. I saved a ton of money buying them from Amazon versus the local Jeep dealership. I dropped these off along with the fender flares and a set of 25 nylon expansion rivets I also purchased through Amazon. A couple of hours later I picked up my Jeep and could not be happier with the result. I will always do a search on Amazon for any and everything prior to purchasing items like this at full retail pricing. I saved big and the installer just assumed I bought the rivets and fasteners from the dealership. Several months and several thousand miles later all is working perfectly! Highly recommend these things to anyone in the market.

avatar

tonykazReviewed in the United States on November 8, 2021

Don't think about reusing them. They are made from a soft composite that breaks apart the moment you try to remove them. So they are a pain in the neck to remove. The heads break off or they flex so much that the body just stays in the hole while the neck elongates. Or the head bend up at the halfway and just cracks in half with the pin still in the hole. Just crap. But they hold well once they are in. Fitment is good; they can be hard to press in. They are way cheaper than the ones I bought from the dealership so i'd say they are a good value but they are not very good quality.

avatar

Jonathan W HaysReviewed in the United States on September 7, 2021

Purchased to use on my Tahoe to replace some of the missing ones, but had to use on a couple other cars also. Great item to have on hand anytime working on a car that uses them. The multiple sizes made it extremely easy to grab what was needed. BTW, I looked like a super dad when I whipped these out for my son's truck.

avatar

Generic UserReviewed in the United States on October 29, 2016

I gave a cart corral a little love tap with my rear passenger fender in a WM parking lot. My fender didn't come off, but the front of it was loose. Drove it around until I could figure out how to fix it, turns out this is a fairly common problem (fender accidents, not necessarily with the corral). So, ordered these along with a couple of other necessary parts, took the fender/wheel well assembly apart to do so. Some of the old ones were a PIA to get out of the fender because they had been painted in place, but I persisted. Put these in and reassembled, you'd never know what happened.

avatar

drackett77Reviewed in the United States on April 24, 2015

I used these to replace the broken clips on the fenders of my jeep JK. I pulled the fenders to trim them and found that more than half of the stock ones were broken. Purchasing the OEM version was stupid expensive, so I went with these. You can tell a bit of a difference in the quality of the plastic, however they have held up really well and snap into place just like the stock ones. Overall, I'm incredibly pleased. The serve the purpose very well, and are cheaper than the OEM. What more could you ask for?!

avatar

Megan HilesReviewed in the United States on January 10, 2022

I may have gotten the wrong sizes bu

avatar

KevinReviewed in the United States on December 8, 2022

I had to replace the old ones and replace them with new ones without any problems it’s fitted well.

avatar

ijagcReviewed in Mexico on October 23, 2019

Lo compre para un explorer 99 y le quedo bien en las puertas y la moldura de las salpicaderas

avatar

michelleReviewed in Canada on April 10, 2018

Great option compared to dealer pricing which was outrageous for the amount that was required. Purchased for son, bought a different set from another seller they did not work at all - These were exactly what he was looking for and worked perfectly for applying his back fenders back on to his 2013 Jeep Wrangler Sport.

avatar

CHRIS DYWELSKAReviewed in Canada on June 4, 2018

these worked perfect to put the oem flairs back on the jeep, just what I was looking for at a good price.

avatar

PPReviewed in Mexico on March 21, 2020

los he usado ya algunas veces sin dudas son buenos y muchos mas baratos

avatar

Javier ZamarripaReviewed in Mexico on November 19, 2019

Servicio muy rápido y producto de buena calidad